Why Bleeder Resistors
This directory contains USENET articles Mic
has saved about guitars, equipment, pickup, techniques, players,
and so on. Mic has graciously granted permission to post the
stuff on the JT30 page on the off chance that it might be useful
in the context of Blues Harmonica. Mic is not responsible for
the content, just the collection.
Questions and Answers
Why Bleeder Resistors
Why Bleeder ResistorsFrom ha--(at)--ortel.ca Wed Dec 18 12:45:14 CST 1996
From: henry--(at)--nr.ca (Henry Pasternack)
Newsgroups: rec.audio.tubes
Subject: Re: Tube amp design notes.
Date: 18 Dec 1996 16:25:18 GMT
Reply-To: ha--(at)--ortel.ca
Andy Moss (enz--(at)--bm.net) wrote:
: Henry, you wrote a few messages back about two 10K bleeder resistors in
: your tube amplifier. I had mentioned that I found that rather suspect
: and you, if I recall, stated it was a generally accepted way of doing
: things.
: I still don't believe. I would like you to provide some kind of *proof*
: to this end.
: I think that you may have misunderstood a different design as I can see
: no positive benefit to such excessive "bleeding". It reminds me of
: "leeching" as being acceptable in medicine years ago.
: In short, lay the science on me - not the conjecture.....
The output voltage of a choke-input filter is approximately 0.9 times
the RMS secondary voltage under load. Unloaded, there is no current flow
through the choke, which effectively "disappears". The filter now looks
like a capacitor-input, and the output rises to 1.4 times VRMS. To keep
the supply under regulation, it is necessary to draw a minimum amount of
current from it. Working through the math (which is tedious because you
have to do it in the time domain), you end up with a standard equation
that states, Imin = VDC / L, where L is given in Henrys. For instance,
a 400VDC supply with a 10H choke-input filter requires 40mA of bleed
current. In practice, the choke's inductance will rise at low currents,
allowing a lower bleed current. There are such things (although they
are not common these days) as "swinging chokes" -- chokes designed
deliberately to have much higher inductance at low currents than at
full load -- intended specifically for choke-input filter applications.
I don't have a specific reference handy, but you certainly can find
a discussion of all of this in the RDH, the Radio Amateur's Handbook,
the RCA Receiving Tube Manual and so on. It's for real, trust me.
-Henry
--
ATTENTION! Reply to ha--(at)--ortel.ca (henry--(at)--ortel.ca won't work).
Index:
|
