Mic Kaczmarczik's
Fender Reverb Transformer Information
Fender Reverb Transformer
Fender
Fender Reverb Transformer
This directory contains USENET articles Mic
has saved about guitars, equipment, pickup, techniques, players,
and so on. Mic has graciously granted permission to post the
stuff on the JT30 page on the off chance that it might be useful
in the context of Blues Harmonica. Mic is not responsible for
the content, just the collection.
Fender
Fender Reverb Transformer
From Dr.Distortio--(at)--bs.mhv.net Mon Mar 13 23:13:44 CST 1995
Article: 458 of alt.guitar.amps
From: Dr.Distortio--(at)--bs.mhv.net (Dr Distortion)
Newsgroups: alt.guitar.amps
Subject: Re: reverb transformer
Date: 13 Mar 1995 23:27:19 GMT
Organization: MHVNet, the Mid Hudson Valley's Internet connection
Lines: 29
Message-ID: <3k2kcn$n7--(at)--ver.mhv.net>
References: <3jl47d$7n--(at)--rime.mdata.fi>
NNTP-Posting-Host: csbh.mhv.net
X-Newsreader: TIN [version 1.2 PL2]
Mikko Oksa (oks--(at)--its.mdata.fi) wrote:
: Anybody have data on the 125A20B impedance matching transformer used in
: Fender reverb circuits ? What kind of a transformer would I need If I
: were to build a silmilar circuit ?
I don't have the data handy, but I can tell you how to figure it out.
1) All Fender reverb tanks have an 8-ohm nominal input impedance. So, the
secondary winding must be 8 ohm.
2) Are you talking about the transformer that was used with a 12AT7 driver?
In that case, the primary impedance of the transformer would probably
be chosen to more-or-less match the plate impedance of the tube, which
gives you maximum power transfer with a triode. Since both halves of the
12AT7 are being used, the plate resistance is 1/2 that of the stated
spec in the tube manuals. So, look up the plate resistance for a 12AT7
at the kind of plate voltage which it sees in the Fender circuit and
divide it in half; that will give you the approximate primary Z of the
transformer, assuming that they designed the xfmr to match the plate
resistance. An even better way is to obtain the actual transformer
and take measurements; feed a 1-volt, 1kHz sine wave into the secondary
and read the AC voltage appearing across the primary. This will give
you the turns (step-up/step-down) ratio. The impedance ratio is the
square of the turns ratio.
__|__ Dr.Distortion __|__
----- STAUDCO -----
/~~~| New York |~~~\